Support

The power supply port can be expanded through cascading switches or using PoE injectors (Midspan).

Yes, data and power are transmitted through the same Ethernet cable without interfering with each other.

Check the quality of the network cable or replace the cable.   

 Reduce device power requirements (such as disabling non essential functions).   

 Ensure that the switch is not operating at overload.

1. The device does not support PoE.  

2. The total power of the switch is insufficient.  

3. The network cable is damaged or too long.  

4. The PoE function of the switch is not enabled (some models require manual activation)

High power models may require a good heat dissipation environment, and it is recommended to install them in a ventilated location to avoid high temperature environments.

Yes, it is. PoE switches have overload protection, short circuit protection, and comply with IEEE standards to ensure safe power supply.

Consider the following factors: 

Number and speed of ports (such as 8/24 ports, 100Mbps/1G).   

 Total power demand (total power ≥ sum of all equipment power).   

 Standard support (PoE, PoE+, PoE++).   

 Management function (whether a network managed switch is required).

Okay. The PoE switch will automatically detect whether the device needs power (through the "handshake protocol"), and only power devices that support PoE to avoid damaging non PoE devices.

Choose a switch with sufficient total power.   Enable the power priority function of the switch (prioritize ensuring power supply for critical equipment)

It depends on the total power and single port power of the switch. For example, a PoE+switch with a total power of 120W can power up to 4 30W devices.

Check if the switch indicator light is powered on (usually with a PoE status light).   View port power status through the management interface (only supported by network managed switches).

Sure, but it is recommended to use Cat5e or higher specification Ethernet cables to ensure stable power supply and data transmission.

The standard maximum distance is 100 meters (consistent with Ethernet transmission distance), but it may be affected by cable quality and power requirements in practice. If the extension mode of the switch is enabled, it can be extended up to 250 meters for power supply and data transmission.

No, The device needs to be clearly labeled as supporting PoE (such as "IEEE 802.3af/at compatible"). Non PoE device connections may cause damage, it is recommended to use a PoE splitter or confirm compatibility.

PoE switches are mainly suitable for the following scenarios:

    Monitoring system (IP camera)

    Wireless network (wireless AP, Mesh nodes)

    VoIP Telephone System

    Intelligent buildings (sensors, access control systems)

    IoT devices (such as smart lighting)

The common standards for PoE:

IEEE 802.3af (PoE): Maximum 15.4W (port output), actual usable is about 12.95W.

IEEE 802.3at (PoE+): Maximum 30W (port output), actual usable is about 25.5W.

IEEE 802.3bt (PoE++): Supports higher power, such as Type3 (60W) and Type4 (90W).

A PoE switch is a network switch that supports simultaneous transmission of data and power over Ethernet cables such as Cat5e/Cat6. It can provide power to connected devices such as surveillance cameras, wireless APs, VoIP phones, etc., without the need for additional power cords.

 Transmission driver download